Single hung
Horizontal roller
Casement
Bay & bow
Sliding glass doors
Entry doors
Impact garage doors
PGT
CGIFree in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterAwning & Hopper Windows in Tampa, FL
Awning windows hinge at the top and swing outward from the bottom, letting you keep them open during a passing Tampa rain shower without water reaching the sill. Hopper windows hinge at the bottom and tilt inward, built for basements, bathrooms, and tight spaces where airflow matters but wall space doesn’t. Both operate on a crank or handle rather than sliding tracks, which means fewer moving parts to bind in Florida humidity and a tighter seal against wind-driven rain. At Lightwell Windows Tampa, we install both styles using products from Mr-Glass, PGT, and ViewLux, with a written price before any work starts. If you’re comparing Window Installation options in Tampa, this page covers what awning and hopper windows cost here, when they’re the right choice, and exactly how our crew handles the work inside your home. Call (850) 360-6785 for a free estimate.
A light well is what brings daylight deep into a building. That’s what a well-installed awning or hopper window should do for your home, pull light and air into rooms that need it, without inviting the weather in behind it.
When You Need Awning & Hopper Windows
Tampa homes run into specific situations where awning and hopper windows outperform standard double-hungs and sliders. Here are the scenarios we see most often in the neighborhoods we serve, from Seminole Heights to Westchase, where Casement Windows or standard options don’t cut it:
- Rain protection with ventilation. During Tampa’s afternoon summer storms, an awning window’s top hinge lets you keep it open for airflow while the sash acts like a small awning, deflecting rain away from the opening. Homes along Bayshore and Davis Islands ask about this constantly during hurricane season.
- Bathroom and laundry-room airflow. Rooms with small wall openings, or windows installed high on the wall near the ceiling, often do best with a hopper or awning style. You get full operation in a compact frame without a slider taking up horizontal wall space.
- Basement and ground-floor egress areas. Hopper windows are common in Tampa’s older bungalow basements and under-house storage spaces. They tilt inward at the top, so you can open them from above without reaching awkwardly.
- Sealing against wind-driven rain. If you’ve noticed water collecting on the sill after storms, or streaks running down the interior wall below a window, the compression seal on an awning window often fixes that where a sliding window keeps leaking.
- Hard-to-reach placement above counters or tubs. Crank-operated awning windows work well above kitchen sinks and bathtub surrounds where reaching a double-hung sash is difficult and pulling a slider could pinch fingers.
- Energy loss in west-facing rooms. Awning windows seal tighter than many slider designs when closed, which matters on Tampa’s west-facing walls that take the full force of the late-afternoon sun.
Our Awning & Hopper Windows Process
We follow the same careful sequence on every awning and hopper installation, regardless of brand or room. The C.A.R.E. values are not a slogan for us. They are the checklist: Clean up like it’s our own home, Ask before we move or touch anything, Respect your family’s time and quiet hours, and Explain the price before the work.
- Measure and quote at the appointment. Keith Yamada or one of our background-checked technicians measures the rough opening, checks the existing framing for rot or water damage, and walks you through which brands fit your budget. You receive a written price before any work starts. Not an estimate range. A number.
- Product selection without pressure. We’ll show you Mr-Glass, PGT, or ViewLux options that match your opening size and style. If a crank-operated awning unit fits better than a hopper, we’ll say so. If the reverse is true, we’ll say that instead. The recommendation fits the home, not the installer’s preferred vendor.
- Interior protection before the first cut. Shoe covers go on at the door. Drop cloths cover the floor and any nearby furniture. If the job is near a child’s room, we confirm nap-time schedules and plan loud work around them. Pet-safe caulk and sealants are used wherever alternatives exist.
- Removal, inspection, and prep of the opening. The old window comes out carefully. We inspect the rough opening for moisture damage, add new flashing where needed, and resolve any rot before the new unit goes in. This is where a lot of rushed installs fail in Tampa’s humidity.
- Installation, sealing, and operation check. The new unit is set, shimmed, squared, and secured. We flash, seal, and insulate the perimeter, then run the crank or handle through a full open-and-close cycle several times to confirm operation. You watch us do this before we leave.
- Clean-up, photo, and walkthrough. We vacuum, wipe down the glass inside and out, remove drop cloths, and show you a photo of the clean area before the crew leaves. Then we walk the job together and you sign off before we’re done.
Awning & Hopper Windows Pricing in Tampa
Awning and hopper window installation in Tampa typically runs between $450 and $1,100 per window for the full project, including the unit, materials, and labor. Smaller hopper windows in basements or utility rooms often land at the lower end of that range. Larger awning units with impact-rated glass, which many Tampa homeowners choose for storm-season performance, fall at the higher end. Here’s how the costs typically break down:
| Component | Typical Range (Per Window) |
|---|---|
| Standard hopper window, vinyl frame | $180 – $350 |
| Standard awning window, vinyl frame | $220 – $450 |
| Impact-rated awning window (PGT or Mr-Glass) | $400 – $800 |
| Labor, flashing, sealing, and clean-up | $200 – $400 |
| Removal and disposal of existing window | $50 – $150 |
Several factors move the price within these ranges. The size of the rough opening matters first. A 2-foot-by-2-foot hopper costs less than a 4-foot-by-2-foot awning unit simply because of material volume. Impact-rated glass and frame reinforcement, common in Tampa for windstorm protection, adds cost but may be required depending on the structure and your insurance carrier’s expectations. Rot repair in the rough opening or the need to resize an existing hole can add a few hundred dollars. And the choice between Mr-Glass, PGT, and ViewLux changes the unit price even when the installation labor stays the same. Most single-window projects finish in one visit, usually four to eight hours including clean-up.
You’ll never get a loose estimate from us. The written price we give you before work begins is the price you pay when the crew leaves. That’s the Cedarwell Care Promise and the 365-Day Done Right Promise in practice: if the finished work is not right, we make it right, no debate, no countdown. Call (850) 360-6785 for a free estimate on your specific openings.
FAQs – Awning & Hopper Windows
How much do awning and hopper windows cost in Tampa?
Most awning and hopper window replacements in Tampa run between $450 and $1,100 per window installed, with standard vinyl hopper units at the lower end and impact-rated PGT or Mr-Glass awning units at the upper end. The biggest cost drivers are glass rating, frame size, and whether any rot repair is needed in the opening. We put your exact total in writing before any work starts, so the number never changes at the end. Call (850) 360-6785 and Keith will walk through your specific window sizes with you.
Are awning windows better than hopper windows?
Awning windows are better for rain protection and locking in tightness on walls that face weather directly, which makes them a strong fit for many Tampa homes. Hopper windows are better for small, high, or awkward openings and cost slightly less on average. The right choice depends on where the window sits and how you use the room, not on a universal ranking-whether that’s these styles or Bay & Bow Windows for a different space.
Can you install awning or hopper windows the same day?
If your window is a standard size and the rough opening is in good condition, we can often complete the installation in one visit, usually four to eight hours, and sometimes schedule it within the same week you call. Custom-sized units or openings that need rot repair add lead time and a second visit. We confirm the timeline during the measurement appointment, before you commit to anything.
Do awning windows seal well against Tampa storms?
Awning windows seal better than sliding or double-hung windows in most cases, because the crank mechanism pulls the sash tight against the weatherstripping around all four edges when closed. Impact-rated awning units from PGT or Mr-Glass add reinforced glass and frames for windstorm performance. If you’re in a flood or wind zone, we’ll recommend what fits your structure and needs, and explain the difference between impact-rated and standard glass before you choose. For plant lovers, we also install Garden Windows with similar protection.
How much does it cost to replace a hopper window in a Tampa basement?
A standard hopper window replacement in a Tampa basement typically costs between $450 and $700 total, including the unit, removal of the old window, and installation labor. Basement openings in older Tampa bungalows sometimes need frame repair, which can add a few hundred dollars. We always inspect the opening before quoting, and the written price you get before work starts covers the entire job as described.
Why Tampa Homeowners Choose Lightwell for Awning & Hopper Windows
Every window we install is covered by the 365-Day Done Right Promise: if the finished work is not right, Lightwell makes it right. No debate, no countdown. Every job is performed by background-checked, uniformed technicians who arrive with shoe covers and drop cloths, respect quiet hours, and leave with a photo of the clean-up on record. A live person answers the phone 24/7, which matters most when a window is leaking at 2 a.m. and you need to talk to a human, not a recording. We carry three manufacturer lines for awning and hopper applications, Mr-Glass, PGT, and ViewLux, so the recommendation fits the home, not the installer’s preferred vendor.
Part of the Cedarwell network and operating to the Cedarwell Care Promise since 2010, Lightwell Windows Tampa is independently owned and operated, led by Keith Yamada. When you call, you’re talking to the people who will stand behind the work. If you’re starting a larger Window Installation in Tampa project, this is the same crew and the same care applied to every opening in the house.
Key Takeaways
- Awning windows hinge at the top and open outward, keeping rain out while allowing ventilation, perfect for Tampa’s afternoon storms.
- Hopper windows hinge at the bottom and tilt inward, ideal for basements, bathrooms, and small or high openings.
- Most installations in Tampa run $450 – $1,100 per window, with impact-rated units at the higher end.
- Every Lightwell job includes a written price before work begins, shoe covers and drop cloths, and a photo of the clean-up before the crew leaves.
- The 365-Day Done Right Promise covers every install. If it’s not done right, we make it right.
Call (850) 360-6785 today for a free estimate on awning or hopper windows in Tampa. Keith will set up a measurement visit at your convenience, answer any questions about brands or glass ratings, and give you a fixed written price before any work begins. No surprises at the end. That’s how we work.
Written by Keith Yamada, Owner at Lightwell Windows Tampa, serving Tampa.
Six Reasons Homeowners Choose Lightwell Windows Tampa
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.